Fence Installation in Cypress, TX
A fence project in Cy-Fair comes with an HOA packet, a MUD, and a back line where water stands for days. You do not have to work any of that out. We measure, hand you the spec sheet the committee wants, and build it.
- HOA spec sheet, handled for you.
- Posts 24 inches into concrete.
- Most yards finished in days.
Get Instant Quote
Professional Quotes for Houston & Central Texas
What can we help you with?
Pick one or more. No contact details needed yet.
Quick Overview
Cypress Fence Basics, No Homework Required
- Installed cost: $30-$50 per linear foot, and a typical Cy-Fair yard lands at $4,500-$7,500
- Wood choice: Pressure-treated pine at $15-$30 per foot, cedar at $36-$50, and we will tell you honestly which suits your run
- Post depth: At least 24 inches in concrete, below the clay layer that moves and unlatches gates
- Standing water: A rot board at $4-$8 per foot takes the ground contact so your pickets do not sit in it
- Approvals: Cypress is unincorporated, so height and material come from your HOA covenants rather than a city counter, and we prepare the submittal detail
- Next step: Call 512-290-5153 with rough footage and we take it from there
Direct Answers
The Worries We Hear First
Installed work runs $30 to $50 per linear foot, which puts most Cy-Fair backyards between $4,500 and $7,500 depending on wood and gate count.
You submit it, but not alone, because we prepare the height, material, cap detail and run drawing in the format architectural committees ask for.
Clay shrinks around the posts when tree roots pull moisture out of it in drought, and the gate side moves first because it carries the most weight.
Why Cypress Is Different
Why Fences Lean Here, and Why It Is Not Your Fault
If your fence has gone crooked faster than it should have, there is a reason, and it has very little to do with how you maintained it. Two ground conditions and one layer of paperwork explain almost every fence call we take in Cypress.
The Back Line Is the Low Point
Here is the part nobody mentions at closing: Cypress drains water that starts in Waller County, about sixty square miles of upper watershed, and on prairie this flat it arrives as a shallow sheet and simply sits. Your back fence line is often the low point of the lot. Posts that sit in saturated soil for two or three days at a time lose the friction that holds them plumb, and the pickets closest to grade wick that water straight up into the end grain. None of that is your fault and none of it is unusual. It is just the ground.
Roots Pulling Your Gate Out of Square
If you live northeast of US 290, in the wooded sections, there is a second thing working against you, and it is the reason your gate stopped latching. Pine and oak push roots up to fifty feet sideways, and when they pull moisture out of montmorillonite clay in August the ground shrinks around your posts. The gate side moves first because it carries the most weight. We auger through the roots we have to, oversize the gate posts, and set everything at least twenty-four inches deep in concrete, below the layer doing the moving. Then the latch stays where we left it.
No City Hall, Two Boards, One Packet
The paperwork is the part that stalls most Cypress fence projects, because there is no city hall to call. Everything civic routes through Harris County, your MUD and your HOA, and in nearly all of 77433 the architectural committee sets height and material before anyone touches a post hole. We put the material list, height, cap detail and a drawing of the run in your hands in the format committees ask for, so you submit once instead of three times. The 1990s and 2000s builder pine fences across Fairfield, Coles Crossing and Stone Gate are all hitting replacement age at the same time.
Cypress: 77065 · 77095 · 77429 · 77433
Typical Fence Installation Scopes in Cypress
Expect $30-$50 per linear foot installed, with most Cy-Fair yards at $4,500-$7,500. Pine runs $15-$30 per foot, cedar $36-$50. Add a rot board at $4-$8 per foot where water stands. Project minimum is $500; gates and removal are separate lines.
Cedar Privacy Replacement, Prairie Lot
Builder pine swapped for cedar on a wet back line
A twenty-year-old builder fence came out and six-foot cedar went back on pressure-treated posts. A rot board took the ground contact along the back run where sheet flow stands after storms.
| Run length | About 190 linear feet |
| Duration | 3 days |
| Lead time | Booked the week after HOA sign-off |
| Products | Cedar pickets, pressure-treated 4x4 posts and 2x4 rails, rot board, galvanized fasteners |
Wooded-Lot Build With Oversized Gate Posts
Augered through lateral roots, gate side reinforced
Holes cut through pine roots running under the line, posts set deeper than standard on the gate side, and the single gate hung and adjusted until the latch closed clean without lifting.
| Run length | About 150 linear feet plus a single gate |
| Duration | 3 days |
| Lead time | Booked within 2-3 weeks |
| Products | Cedar pickets, oversized gate posts, ready-mix concrete, Simpson Strong-Tie hardware, gate hardware |
Pine Perimeter With Double Gate
Budget-first build with trailer access
Pine held the per-foot cost where the budget needed it, with a double gate cut in for trailer access. Pickets sat clear of grade so the back run does not wick after a storm.
| Run length | About 170 linear feet plus a double gate |
| Duration | 2 days |
| Lead time | Next available crew slot |
| Products | Pressure-treated pine pickets and posts, 2x4 rails, concrete mix, double gate hardware |
Site Conditions
What We Look At Before We Pick Up a Shovel
You do not need to know any of this before you call. We read it on site, and it decides the footing plan and where the gate goes.
| Condition | Where you see it in Cypress | What it needs |
|---|---|---|
| Sheet flow standing along the back line | Prairie lots in Bridgeland, Miramesa, Marvida | Rot board, pickets held off grade, and water routed past the posts before the first hole is augered |
| Clay shrink-swell around the footings | Every subdivision in Cy-Fair | Posts a minimum of 24 inches into concrete, below the layer that moves with the seasons |
| Lateral tree roots under the fence line | Wooded sections northeast of US 290 | Augered through where needed and panel runs broken shorter so one moving post does not drag the rest |
| Formosan termite pressure | Established countywide, all lots | Pressure-treated posts only, nothing untreated in ground contact, and existing posts probed at removal |
| HOA covenant on height and material | Nearly all of 77433 and most of 77429 | Spec sheet and run drawing prepared for your architectural submittal before the build is scheduled |
| Old footings from the builder fence | 1990s and 2000s subdivisions, replacement wave | Concrete pulled out with the posts so the new line sits where it should, priced into the removal |
Materials
What We Build Cypress Fences Out Of
Cedar pickets on pressure-treated 4×4 posts with pressure-treated 2×4 rails is the usual Cy-Fair build, set in ready-mix concrete and tied together with galvanized fasteners, Simpson Strong-Tie bases and proper gate hardware. Pine is the budget route and vinyl panels or metal are on the table where your covenants allow them. A rot board goes on wherever water stands. Layout comes off a laser level, holes off a gas auger, screws off Milwaukee M18 drivers.
| Product | Brand | Why it earns the spot |
|---|---|---|
| Bosch rotary laser level | Bosch | Keeps fence lines and post heights consistent. |
| Cedar fence pickets | Cedar | Common privacy fence material. |
| Gas-powered post-hole auger | Earthquake / STIHL | Used for post-hole excavation. |
| Milwaukee M18 drill/driver | Milwaukee | General drilling and fastening. |
| Pressure-treated 2x4 rails | PT lumber | Horizontal support members. |
| Pressure-treated 4x4 fence posts | Treater-grade lumber | Primary structural fence posts. |
| Ready-mix concrete | Quikrete / local batch mix | Used for post footings. |
| Simpson Strong-Tie post base / brackets | Simpson Strong-Tie | Used where code or design calls for extra reinforcement. |
Material grades are specified per substrate after the on-site walkthrough. Material prices are carried in the project scope.
Pricing
Cypress Fence Pricing, Plainly
Linear footage sets the baseline. Wood species, gate count and removing what is there now move it.
| Scope | Typical Cypress range | What drives the spread |
|---|---|---|
| Pressure-treated pine fence | $15-$30 per linear foot | Height, picket grade, and how many posts the old line can give back |
| Cedar fence | $36-$50 per linear foot | Picket width, three-rail versus two, and the cap detail your covenants call for |
| Premium hardwood fence | $50-$80 per linear foot | Species availability and milling, plus committee approval on a non-standard look |
| Gates | $150-$400 single, $300-$900 double | Opening width, frame weight, and the oversized hinge-side post this clay demands |
| Old fence and footing removal | $200-$700 | Run length and how much builder-era concrete comes out with the old posts |
Minimum project size is $500. Every figure is confirmed on site before work starts.
Process
What Happens After You Call
- 1You call 512-290-5153 and stop thinking about it. Rough footage is enough to start. Projects begin at $500 and we will tell you on the phone if your job is really a repair.
- 2We walk your line with you. Footage measured, property line flagged, and we show you where water stands and where the grade falls away from the fence.
- 3We prepare the HOA detail. Height, material, cap detail and a drawing of the run, written the way architectural committees want to receive it. You submit, we wait with you.
- 4Holes get augered to depth. A gas auger cuts at least 24 inches, deeper on gate posts, through roots where the wooded lots demand it.
- 5Posts, rails, pickets, in that order. Posts set in ready-mix concrete and plumbed off a laser, rails tying them together, then pickets faced on galvanized fasteners and held off grade.
- 6Gates hung, site cleared, latch tested. Hardware adjusted until it closes clean with one hand. Old fence, footings and offcuts all leave with the crew.
Coverage
Cypress Neighborhoods We Fence
Covenants and ground conditions differ by subdivision, so we read both before quoting. These are the Cy-Fair areas our crews run.
Our Services
Other Things We Can Take Off Your List
While a crew is already at your address, the rest of the backlog is easier to clear than you think.
Handyman Services
Post resets, replacement pickets and the twenty other small things nobody got to. One visit, one ticket, $500 project minimum for multi-item work.
Painting Services
Exterior trim, soffit, fascia and front doors, prepped properly. In Cy-Fair your HOA usually has an approved palette, and we will pull the color codes from it.
Drywall Installation
Full wall and ceiling replacement, hung, taped and finished. Where standing water reached the board we replace the affected wall plane rather than covering it over.
Flooring Installation
LVP, laminate, hardwood and carpet over a slab that gets moisture tested first. Transitions finished and the old floor hauled away with us.
Tile Installation
Floors, showers and backsplashes set over proper membranes. Tile is the first-floor finish that shrugs off standing water, which matters on this side of Harris County.
Common Questions
Cypress Fence Installation FAQs
Do I need a permit for a fence in Cypress?
Cypress is unincorporated, so there is no city fence counter. Your height and material limits come from HOA covenants and deed restrictions instead, and we prepare the detail you submit to the committee.
Will you reset my leaning posts or re-stain my fence?
Not under fence installation, which covers new runs and full replacements only. Post resets, picket swaps and stain-only work belong on a handyman visit, and we are happy to book it that way.
How long does a Cypress fence take to build?
One to five days of build time with two to four installers. On longer runs the concrete cures between post day and picket day, so the crew returns rather than rushing it.
Cedar or pine for a Cy-Fair backyard?
Both are reasonable. Pine at $15-$30 per foot stretches a budget furthest; cedar at $36-$50 holds its shape better against humidity and standing water. Your covenants may already decide it.
Is a rot board worth the extra money here?
On most Cypress lots, yes. Sheet flow stands rather than draining, so something is going to sit in water, and at $4-$8 per foot a rot board takes that hit instead of your pickets.
What if my HOA turns the submittal down?
Then we revise the spec and resubmit with you. Nothing gets scheduled or charged until your committee has what it needs, so you are not left holding a build you cannot put up.
Can you take out the old fence too?
Yes, including the footings. Removal runs $200-$700 inside an installation depending on run length and how much concrete comes out, and it all leaves on our trailer.
What is the smallest fence job you will take?
The project minimum is $500, so a side-yard run, a short back line or a gate section all qualify. Call 512-290-5153 with rough footage and we will price it honestly.
What You Can Expect From Us
The Packet Is On Us
Height, material, cap detail and a drawing of your run, prepared for your architectural committee. You sign and send; you do not research covenants on a Sunday night.
Depth Over Speed
Every post goes at least 24 inches into concrete, deeper on gates. It is the single decision that keeps a Cy-Fair gate latching three summers from now.
Water Planned For, Not Ignored
Where sheet flow stands along your line we route it past the posts and put a rot board in the ground contact. The wet spot is accounted for in the quote.
One Crew, No Open Yard Overnight
Two to four installers run removal through gate hang. Your yard is not left open with a dog in it while somebody waits on material.
Let Us Carry the Cypress Fence Project
Hand us the measurements over the phone at 512-290-5153 and the HOA packet stops being your problem. Most Cy-Fair yards go up in one to five days, so Saturday is free for the Bridgeland trails.
Our Cypress Homeowner Resources
Drywall Installation · Flooring Installation · Handyman Services · Painting Services · Tile Installation