How Much Does Drywall Installation Cost in Houston? (2027)
Houston drywall installation is priced per square foot of board: $2-$6 hung, taped and finished, for full walls and ceilings only. Beaumont clay cracks Houston walls at door and window corners, so the crack pattern is read before any board is ordered.
Prices reviewed November 15, 2026. Reviewer: Handyman Install.
- Priced per square foot
- Full walls and ceilings only
- Level 3, 4 or 5 finish

Estimate your project
Price ranges for the Houston area
What can we help you with?
Pick one or more. No contact details needed yet.
Used to price the job for your area.
Your quote is ready
Where should we send it?
From $500
Houston metro rate
Quote Breakdown
Materials we use:
Reflects our $500 project minimum.
Ready to book the walkthrough? Call to schedule it.
512-290-5153Quick Overview
Houston drywall costs at a glance
- New board, installed: $2-$6 per sq ft hung, taped and finished.
- Texture match: $0.80-$1.50 per sq ft (national), orange peel or knockdown.
- Skim coat: $1.10-$1.30 per sq ft (national), toward a Level 5 surface.
- Scope: Full wall and ceiling replacement; single holes and patch-only calls go to a patch-focused crew.
- Location adjustment: Inner Loop zips run 20% over the metro drywall figures. No other Houston-area zip changes the rate.
- Crew and duration: Two to three installers; one to four days for most Houston drywall jobs.
Direct Answers
Drywall installation costs in Houston, answered
New drywall in Houston runs $2-$6 per sq ft hung, taped and finished, with texture and skim coat priced as separate lines.
Each finish level adds compound coats and sanding time; national finishing labor runs $1.50-$2.75 per sq ft at Level 3 and $1.75-$3.50 at Level 5.
No. Houston drywall work here is full wall and ceiling replacement, so we replace the affected wall plane and send single holes to a patch-focused crew.
Why Houston Is Different
What Houston does to walls and ceilings
Clay movement, growth faults and water explain most of the spread inside the Houston drywall range, because each one changes how much board comes out and what has to happen first.
Beaumont clay racks Houston openings
Beaumont Formation clay swells after rain and shrinks through a dry summer, lifting and dropping slab edges unevenly. The board above cracks diagonally out of door and window corners, so the slab gets assessed before a full wall plane is replaced.
Growth faults reopen the same Houston crack
More than 300 active growth faults cross the Houston metro. A house that straddles one tilts along that line, and new board over an active trace cracks again in the same place, which is why the walkthrough reports it first.
Water reaches Houston ceilings and walls
Downtown Houston sits about 50 ft above sea level on flat ground, and Allen Parkway floods after heavy rain. Indoors, a clogged attic condensate line soaks ceiling board out of sight; board wet longer than about 48 hours comes out, and mold remediation stays with a separate trade.
Houston: 77002 · 77006 · 77007 · 77008 · 77036 · 77084
Typical drywall installation scopes in Houston
Drywall installation in Houston runs $2-$6 per sq ft hung, taped and finished, and Inner Loop zips price about 20% above that range. Most Houston drywall estimates come from one of three scopes.
Wall replacement
Cracked wall planes in a Houston slab house
Board comes off to the studs, corner bead is reset on every outside angle, and the new plane is taped, coated and sanded to the finish level on the estimate.
| Finish | Level 4 for most painted walls |
| Duration | 1-4 days |
| Crew | 2-3 installers |
| Products | USG Sheetrock, paper tape, corner bead |
Ceiling replacement
Stained or sagging Houston ceiling board
The water source is corrected by its own trade first. The affected ceiling plane then comes down, new board goes up against a laser line, and the texture is matched to the rooms around it.
| Texture | Orange peel or knockdown |
| Duration | 1-4 days |
| Crew | 2-3 installers |
| Tools | Bosch laser level, drywall stilts |
Remodel and addition board
New walls in a Houston remodel
Fresh framing in a kitchen, bath or addition gets board hung and finished on the same calendar as the trades around it, with a Level 5 skim where raking light will show seams.
| Finish | Level 3, 4 or 5 |
| Duration | 1-4 days |
| Crew | 2-3 installers |
| Pairs with | Painting services |
Site Conditions
Houston wall conditions we price against
Houston drywall estimates price what sits behind the board as much as the board itself. Each condition below is read and recorded on the walkthrough.
| Condition | Where you see it in Houston | What it needs |
|---|---|---|
| Diagonal cracks at door and window corners | Slab houses on Beaumont clay | Slab assessed, then the affected wall plane replaced |
| A crack that returns on one line | Houses over a growth fault | Fault read reported before any new board |
| Ceiling stain under the attic air handler | Attic condensate lines | Line corrected by its trade, then the ceiling plane replaced |
| Board wet longer than about 48 hours | Leaks and flood rebuilds | Removed; mold remediation by a separate trade |
| Plaster over wood lath | Pre-1960 houses inside the Loop | Demolition and containment quoted after the walkthrough |
| Single hole or doorknob ding | Any room | Outside our scope; a patch-focused crew |
Materials
The board and finishing materials behind these Houston numbers
Houston drywall estimates name the board and compound, such as USG Sheetrock 1/2 in. panels at $12-$22 a sheet with USG All Purpose compound at $18-$28 a bucket. Finish level is set per room after the walkthrough.
| Product | Brand | Why it is on the job |
|---|---|---|
| Sheetrock 1/2 in. drywall | USG | Standard interior wall and ceiling panels |
| All Purpose Joint Compound | USG | Seams, corners and final finish |
| Paper or mesh drywall tape | FibaTape / USG | Paper for seams; mesh for specific conditions |
| Drywall screws | Grip-Rite | Fastening board to framing |
| 20V MAX Drywall Screwgun | DeWalt | Sets each fastener to depth |
| 360° laser level | Bosch | Wall and ceiling reference lines |
| Taping knife set | Marshalltown | Applying and smoothing compound |
| Drywall sander | Festool | Dust control while sanding |
Grades are set after the on-site walkthrough, and material prices are carried in the project scope.
Pricing
What drywall installation costs in Houston
New drywall in Houston runs $2-$6 per sq ft hung, taped and finished. Finish level, ceiling height and how much old board comes out decide where a job sits in that range.
Compare other trades on the Houston handyman pricing page, or see drywall installation in Houston for scope and local conditions.
| Scope | Typical Houston range | What drives the spread |
|---|---|---|
| New drywall, hung, taped and finished | $2-$6 per sq ft | Walls or ceilings, finish level, access and board thickness |
| Texture match, orange peel or knockdown | $0.80-$1.50 per sq ft (national) | How far the new texture has to blend |
| Skim coat toward Level 5 | $1.10-$1.30 per sq ft (national) | Raking light, paint sheen and wall area |
| Finishing labor, Level 3 | $1.50-$2.75 per sq ft (national) | Behind heavy texture |
| Finishing labor, Level 4 | $1.70-$3.20 per sq ft (national) | Most painted walls |
| Finishing labor, Level 5 | $1.75-$3.50 per sq ft (national) | Gloss paint or strong window light |
| Plaster and lath removal | Quoted after an on-site walkthrough | Containment, lath and haul-off volume |
Drywall projects start at the $500 minimum, and every figure is checked against your measured walls and ceilings before work starts.
Where these Houston drywall prices come from
New board at $2-$6 per sq ft hung, taped and finished is a Houston market range. Texture and the Level 3 to Level 5 finishing rates are national figures from HomeGuide, and the skim coat range is a national figure from Angi; all three were checked November 5, 2026. Board, compound and tape prices are typical retail ranges, material only.
Drywall material unit costs in Houston
Drywall supply prices in Houston can be checked at any building supplier. The unit ranges below cover the board and finishing materials inside the per-sq-ft figure.
| Item | Typical unit cost | Where it sits in the job |
|---|---|---|
| USG Sheetrock 1/2 in. panel | $12-$22 per sheet | Hanging |
| USG All Purpose Joint Compound | $18-$28 per bucket | Taping and finish coats |
| FibaTape or paper drywall tape | $6-$18 per roll | Seams |
| Grip-Rite drywall screws | $9-$18 per box | Fastening |
Material only. The per-sq-ft installed rate carries this material plus labor.
What the per-sq-ft drywall rate covers in Houston
Two Houston drywall quotes compare only when both carry the same lines. The table shows which lines our drywall rate carries.
| Line item | Inside the rate | Note |
|---|---|---|
| Hanging new board | Yes | Walls and ceilings |
| Tape, compound and corner bead | Yes | Every seam and outside angle |
| Sanding with dust control | Yes | Screens or a dust-extracting sander |
| Finish to Level 3, 4 or 5 | Yes | Level set per room on the estimate |
| Texture match | Separate line | $0.80-$1.50 per sq ft (national) |
| Patching single holes | No | Outside our scope |
| Mold or moisture remediation | No | A separate trade, scheduled before new board |
| Structural framing changes | No | Only inside a larger install project |
Houston conditions that move a drywall quote
A Houston drywall quote moves inside its range for the reasons below; each is read in the room, and none carries a fixed surcharge.
| Condition | Effect on the quote | Why |
|---|---|---|
| Ceiling work or tall walls | Up | Slower access and more lifting |
| Level 5 finish | Up | A skim coat over the full plane |
| Texture match across rooms | Up | Sampling and blending into existing walls |
| Inner Loop zip | Up about 20% | The only location adjustment in the metro |
| Plaster and lath or wet board | Walkthrough first | Removal and containment are scoped before board |
Process
How a Houston drywall estimate gets built
- 1 Measure the planes. Each wall and ceiling plane is measured in square feet, since the per-sq-ft range starts from those numbers.
- 2 Read the cracks. Crack width, direction and history are recorded, and a slab or fault cause is reported before a figure goes on paper.
- 3 Write the estimate. Planes, finish level, texture and named products are listed, so every line traces to a price you can check.
- 4 Protect and remove. Floors and openings are covered, trim comes off, and the old board goes out; wet board is bagged and flagged for remediation by others.
- 5 Hang, tape and finish. New USG Sheetrock goes up against a laser line, then tape and compound coats build the joints to the finish level on the estimate.
- 6 Match and walk. Texture is matched to the surrounding rooms, and each plane is walked with you under a work light before the crew leaves.
Coverage
Houston-area cities we install drywall in
Drywall crews run from inside the Loop out to every city we serve around Houston. Only Inner Loop zips change the per-sq-ft drywall figures.
Our Services
Trades that run with a Houston drywall scope
Drywall usually sits in the middle of a larger Houston project, between demolition and paint, with the trades below on the same calendar.
Painting services in Houston
Finished board takes primer and two coats, and interior painting runs $3-$7 per sq ft of paintable wall area.
Trim and baseboard in Houston
Trim comes off before the old board and goes back square on the new plane, with new baseboard at $3.50-$9 per linear ft (national).
Bathroom remodeling in Houston
Bathroom remodels here include drywall and backer board along with tile and trim; a guest bath runs $12,000-$25,000.
Flood rebuilds in Houston
Flooded Houston rooms follow a set order before new board goes up, and the flood rebuild guide lays that order out.
Common Questions
Houston drywall installation questions
How much does drywall installation cost in Houston?
New drywall in Houston runs $2-$6 per sq ft hung, taped and finished. Texture and skim coat are priced as their own lines.
What does texture matching cost on a Houston job?
Orange peel or knockdown runs $0.80-$1.50 per sq ft (national) on a Houston job, with the texture sampled on scrap board before it goes on the wall.
Which finish level should a Houston homeowner choose?
Level 3 suits heavy texture, Level 4 covers most painted Houston walls, and Level 5 is for gloss paint or raking window light.
Do you patch small holes in Houston?
No. Houston drywall work here is full wall and ceiling replacement with a $500 project minimum, so a single hole goes to a patch-focused crew.
Why does my Houston wall crack in the same place again?
Over 300 growth faults cross the Houston metro. A house over one tilts along that line, and the walkthrough reports it before new board goes up.
Does Houston drywall work need a permit?
Houston permits follow the type of work. Non-fire-rated gypsum work is exempt, while replacing a plumbing or electrical fixture pulls that trade's permit.
How long does a Houston drywall job take?
Most Houston drywall jobs take one to four days with two to three installers, depending on square footage, finish level and drying time.
Can you replace a ceiling after a Houston roof or AC leak?
Yes, once the leak is corrected by its own trade. The affected Houston ceiling plane is replaced, and board wet past about 48 hours comes out first.
How we price and install drywall in Houston
Houston drywall estimates follow four rules, from how each plane is priced to which work stays off the drywall rate.
Each Houston wall plane priced on its own row
Every wall and ceiling gets a row with its square footage and finish level, so one tall stairwell cannot hide inside a total.
Cracks are read before Houston board is ordered
Crack direction, width and history are recorded first, and a slab or fault cause is named on the estimate.
Board and compound named with unit prices
Sheetrock, compound, tape and screws are listed by product, with prices any Houston building supplier can confirm.
Remediation priced outside the Houston drywall rate
Mold and moisture remediation belong to a separate trade, and the estimate schedules new board after that work.
Get the number for your Houston walls and ceilings
Walk the Memorial Park loop on Saturday morning and let us measure the cracked rooms another day that week. Call 512-290-5153 to book the drywall walkthrough.
Our Houston Homeowner Resources
Drywall Installation · Fence Installation · Flooring Installation · Painting Services · Tile Installation