Fence Installation in Conroe, TX
Neighbors out here lose fences to pines. When the sandy ground saturates, root plates let go and a whole tree comes down across the run. We set posts deep in concrete and keep the line clear of the drip zone.
- New runs and full replacements
- Posts 24 inches into concrete
- Most yards up in days
Get Instant Quote
Professional Quotes for Houston & Central Texas
What can we help you with?
Pick one or more. No contact details needed yet.
Quick Overview
Conroe Fence Basics
- What it runs: $30-$50 per linear foot installed, with a typical Conroe yard landing at $4,500-$7,500
- Wood that works here: Cedar at $36-$50 per foot, pressure-treated pine at $15-$30
- Post depth: At least 24 inches into concrete, down through the sand and into the clay
- Rot board: $4-$8 per linear foot, and worth every cent under a pine canopy
- Timeline: One to five days with a crew of two to four installers
- What we do not do: Repair-only work, post resets and stain-only jobs, which belong on a handyman visit
Direct Answers
What Folks Ask Over the Fence Line
Installed fence work runs $30 to $50 per linear foot here, which puts a typical residential yard somewhere between $4,500 and $7,500.
Post holes augered in loamy fine sand hold water above the slow-draining clay below, so a shallow footing sits in a bathtub and works loose.
Yes, as a full replacement run rather than a repair, which is how a crushed line comes back straight instead of following the old lean.
Why Conroe Is Different
Why Conroe Fences Come Down
Ask around the Farmers Market at 1488 and you will hear the same two stories: a pine went over and took forty feet of fence with it, or the gate quit latching after a wet spring. Both come straight out of the ground this town sits on.
Post holes that hold water like a bathtub
Here is the thing about Conroe dirt that catches people out. The surface is a gravelly loamy fine sand, easy augering until you hit the sandy clay plinthite a foot or two down, and that layer barely lets water through. Dig a post hole and you have made a bucket. Rain fills it, water sits against the base of the post instead of draining away, and the footing works loose season by season. So holes go deeper, down into the clay and at least twenty-four inches, with concrete crowned above grade to shed water away from the post rather than collect it at the collar.
Pines that take the whole run with them
Loblolly and shortleaf pine are what makes living here feel like the Piney Woods, and they are also what flattens fences. These trees often do not snap. When the ground saturates the root plate releases and the whole tree lies over, lifting a plate of soil and taking posts, rails and pickets with it. Anybody out near W. Goodrich Jones State Forest has seen it happen. That is why the line gets walked before layout, held clear of the drip zone where the lot allows, and broken into shorter panel sections under canopy so one tree does not cost you the entire perimeter.
Old Conroe and new Conroe fence differently
This city grew more than sixty-five percent since 2010, and that shows up right at the property line. Around the courthouse square and in River Plantation, lots are irregular, old fences sit on footings nobody documented, and tear-out is half the job. Out in Artavia, Evergreen or The Woodlands Hills, the lot is square, the grade was engineered last year, and the architectural committee has opinions about height, material and which way the finished face points. We build both, but they need different lead times and different paperwork.
Conroe: 77301 · 77302 · 77303 · 77304 · 77306
Typical Fence Installation Scopes in Conroe
Figure $30-$50 per linear foot installed, with most Conroe yards landing at $4,500-$7,500. Pine runs $15-$30 per foot and cedar $36-$50. Projects start at $500, and gates, rot board and hauling off the old fence are priced on their own lines.
Cedar Privacy Run Under Pine Canopy
Rot board and shorter panel sections
Six-foot cedar around a wooded back lot, laid out clear of the trunks where the line allowed and broken into shorter sections under the heaviest canopy. A treated rot board took the ground contact so the pickets stayed up out of the needle litter.
| Run length | About 190 linear feet |
| Duration | 3 days |
| Lead time | Within a week |
| Products | Cedar pickets, pressure-treated 4x4 posts and 2x4 rails, treated rot board, galvanized fasteners |
Full Replacement After a Pine Went Over
Crushed run rebuilt straight
A saturated-ground pine flattened sixty feet of fence and lifted two footings out whole. The run came out complete, new holes were augered down into the clay, and the line was re-shot with a laser instead of chasing the old lean.
| Run length | About 150 linear feet, removal included |
| Duration | 3-4 days |
| Lead time | Storm season books 2-3 weeks out |
| Products | Cedar pickets, ready-mix concrete, pressure-treated posts and rails, galvanized screws |
Pressure-Treated Pine with a Double Gate
Reviewed build on a new-build lot
Pine kept the per-foot figure down on a long perimeter in a newer subdivision, with a double gate sized for a boat trailer headed to the lake. Material, height and finished-face direction went through architectural review before anything was augered.
| Run length | About 220 linear feet plus a double gate |
| Duration | 4 days |
| Lead time | 2-3 weeks including review |
| Products | Pressure-treated pine pickets and 4x4 posts, Simpson Strong-Tie post bases, gate hardware |
Site Conditions
Ground and Lot Conditions Before Layout
Before anybody picks a picket, we walk the line and look at what those posts are actually going into. Six things change the footing plan around here.
| Condition | Where you see it in Conroe | What it needs |
|---|---|---|
| Loamy fine sand over slow-draining plinthite | Most of the sandy upland inside Loop 336 | Holes taken down into the clay, at least 24 inches, with concrete crowned above grade |
| Sidewall sloughing while augering | Looser sand on the 1-4 percent slopes | Wider holes or sleeves so the footing keeps its shape as concrete goes in |
| Ironstone gravel in the surface horizon | Willis Formation uplands across the north side | Slower augering and a line in the budget for it, since that gravel chews auger teeth |
| Pine root plates and drip zones | Wooded lots out toward W. Goodrich Jones State Forest | Line held clear of trunks where possible and broken into shorter panel sections |
| Water tracking along a property line | Lots on the downhill side of the perched flow | Drainage planned past the posts before the first hole is dug |
| Lakefront and shoreline exposure | April Sound, Water Crest on Lake Conroe, Rockrose Ranch at Lake Conroe | Galvanized hardware throughout and runs laid out for wind coming off open water |
Materials
What We Build Conroe Fences Out Of
Most runs here are cedar pickets on pressure-treated 4×4 posts with pressure-treated 2×4 rails, set in ready-mix concrete and tied together with galvanized fasteners, gate hardware and Simpson Strong-Tie post bases. A treated rot board carries the ground contact, which matters under pine where needle litter keeps the base of a fence damp for weeks. Lines get shot with a Bosch laser level, holes come from a gas auger, and the screws go in off Milwaukee M18 drivers.
| Product | Brand | Why it earns the spot |
|---|---|---|
| Bosch rotary laser level | Bosch | Keeps fence lines and post heights consistent. |
| Cedar fence pickets | Cedar | Common privacy fence material. |
| Gas-powered post-hole auger | Earthquake / STIHL | Used for post-hole excavation. |
| Milwaukee M18 drill/driver | Milwaukee | General drilling and fastening. |
| Pressure-treated 2x4 rails | PT lumber | Horizontal support members. |
| Pressure-treated 4x4 fence posts | Treater-grade lumber | Primary structural fence posts. |
| Ready-mix concrete | Quikrete / local batch mix | Used for post footings. |
| Simpson Strong-Tie post base / brackets | Simpson Strong-Tie | Used where code or design calls for extra reinforcement. |
Material grades are specified per substrate after the on-site walkthrough. Material prices are carried in the project scope.
Pricing
Conroe Fence Pricing
Linear footage sets the starting number. Wood choice, gate count and whether an old fence has to come out move it from there.
| Scope | Typical Conroe range | What drives the spread |
|---|---|---|
| Pressure-treated pine fence | $15-$30 per linear foot | Height, picket grade and how many posts the run needs |
| Cedar fence | $36-$50 per linear foot | Picket width, rail count and whether a cap detail runs the top |
| Premium hardwood fence | $50-$80 per linear foot | Species availability and the milling on the pickets |
| Gates | $150-$400 single, $300-$900 double | Opening width, frame weight and hardware, plus trailer clearance for the lake |
| Old fence removal | $200-$700 | Run length, footing size and how much haul-off volume there is |
Minimum project size is $500. Every figure is confirmed on site before work starts.
Process
How Your Fence Goes In
- 1Give us a call and a rough footage. One call to 512-290-5153 sets height, material, gate count and the ballpark. Projects start at $500.
- 2We walk the line with you. Property line flagged, trunks and drip zones noted, and the spots where water tracks along the line marked before layout.
- 3Paperwork gets sorted. Conroe runs its own permit desk and the newer neighborhoods have architectural review, so we confirm both before anything is augered.
- 4Holes go into the clay. A gas auger takes holes at least twenty-four inches down past the sand, then posts set in ready-mix with the concrete crowned to shed water.
- 5Rails, rot board, then pickets. Rails tie the posts together, the rot board takes the ground contact, and pickets face it held an inch or two off grade.
- 6Gates hung, yard left clean. Hardware gets adjusted until the latch closes easy, and the old fence and every last scrap leaves with the crew.
Coverage
Conroe Neighborhoods We Fence
We run fences from the courthouse square out to the shoreline communities, up SH 105 and out along SH 242, and the build standard does not change with the address.
Our Services
Other Jobs We Pick Up in Conroe
A fence is usually not the only thing on the list. The same crew handles these, each on its own Conroe page.
Handyman Services
Fence repairs, post resets and stain-only work do not fall under installation, but they are right at home on a handyman visit. So is everything else that has been sitting on your list.
Painting Services
Once the fence is up, the same crew can take on exterior work at the house. Under a pine canopy, prep and timing matter more than which paint you pick.
Drywall Installation
If a limb came through a ceiling, that is a full plane replacement with the texture matched. We rebuild the affected wall plane or ceiling outright rather than patching it.
Flooring Installation
LVP, laminate and hardwood over a slab leveled first, especially at the perimeter where Conroe slab edges tend to run low.
Tile Installation
Floors, showers and backsplashes set over proper membrane, with the layout planned so the cuts land where nobody is looking.
Common Questions
Conroe Fence Installation FAQs
How much does a Conroe fence cost per foot?
Installed work runs $30 to $50 per linear foot, so a typical yard lands between $4,500 and $7,500. Pine is $15 to $30 a foot and cedar $36 to $50.
How deep do posts go in Conroe sand?
At least twenty-four inches, down past the loamy sand and into the clay. Shallow footings sit in a hole that holds water and work loose within a season or two.
Will you reset my leaning posts?
Not under installation, which covers new runs and full replacements. Post resets, repairs and stain-only work route to a handyman visit instead, and we are glad to take it there.
A pine fell on my fence. Now what?
The crushed section comes out as a full replacement run. New holes are augered down into the clay and the line is re-shot straight rather than following the old lean.
Do I need a rot board under pines?
It earns its keep here. Needle litter holds moisture against the base of a fence for weeks, and a rot board takes that hit instead of your pickets at $4 to $8 per foot.
Cedar or pressure-treated pine for Conroe?
Both are realistic. Pine at $15 to $30 a foot stretches a budget over long perimeters; cedar at $36 to $50 holds its shape better through our humidity and canopy shade.
Does my subdivision have to approve the fence?
In the newer master-planned neighborhoods, usually yes, covering height, material and which way the finished face points. We confirm architectural review and the City of Conroe requirement before layout.
How long will the install take?
One to five days for most Conroe yards, with two to four installers. On longer runs the concrete cures between post day and picket day. Call 512-290-5153 with footage.
How We Build Around Here
Depth into the clay
Every post goes at least twenty-four inches down, past the sand and into the layer that actually holds. That is why gates still latch three springs later.
The line gets walked first
Trunks, drip zones and the path water takes along your property line all get noted before a hole is dug. Layout is set from what that walk finds on the ground.
Hardware that survives the damp
Galvanized fasteners and Simpson Strong-Tie post bases hold the frame together. Out here the wood weathers long before the connections do, which is the right order.
One crew, start to finish
Two to four installers run tear-out through gate hang with no handoffs. Nothing sits open overnight and the yard is swept before anybody leaves.
Let's get your Conroe fence measured
Half the trucks at the Lake Conroe boat ramps on a Saturday tow past a fence that needs replacing. Dial 512-290-5153 and we measure this week, with most yards up in one to five days.
Our Conroe Homeowner Resources
Drywall Installation · Flooring Installation · Handyman Services · Painting Services · Tile Installation